Safety in the workplace
It is worth mentioning that dc power supplies can also be extremely deadly if precautions are not taken to remove the input power and completely discharge all capacitors. Older tube transmitter power supplies typically deliver dc outputs of several hundred volts at respectable amperage; it seems pretty obvious these will hurt. However, the power supplies in the newer solid state transmitters and dc UPS/battery backup systems might operate below 100V but would be capable of supplying several hundred amps of current. These low-voltage/high-current power systems are nearly perfect constant current sources.
OSHA specifies requirements to provide proper “Lockout/Tagout of electrical circuits where employees are exposed to electrical hazards while working on, or near, or with conductors or systems that use electric energy.” 29 CFR 1910.333 sets forth requirements to protect employees working on electric circuits and equipment. This section requires workers to use safe work practices, including lockout and tagging procedures.
Tower climbing is now considered the most dangerous job nationally. According to a 1998 study by NIOSH (National Institute for Occupational Safety and Health), 108 tower worker deaths were reported between 1992 and 1998. Of these, 93 were cause directly by falls from structures.
In 2008 alone, 12 deaths were associated with falls from tower structures in the Communication Construction Industry.
It goes without saying that any crew you permit to work on your tower needs to provide proof that it possesses the proper training equipment and training before being permitted to work on a tower, rooftop or other structure. You should always require qualified tower climbers produce a current certification card prior to start of work. Organizations such as the National Association of Tower Erectors (NATE) provide training and certification programs to qualified tower workers.
We became aware of the issues related to non-ionizing radiation back around 1996 when the FCC adopted guidelines to ensure the exposure of employees and the public to RF energy is below stated Maximum Permissible Exposure (MPE) limits. Since that time broadcasters have been required to take steps in preventing casual access and marking areas where levels are in excess of stated limits.
In the event you find yourself in an area rich in RF sources such as a rooftop, there are some signs to watch for to indicate RF exposure: Confusion, vertigo, headache, blurred vision, overall nauseous feeling, body heating, shocks and burns, and bad or metallic taste in the mouth.
It should become a requirement that any employee or subcontractor working in these areas carry some form of RF personal protection monitor with them at all times.
One last word. If it is necessary to work alone be sure to take a few minutes to assess the potential hazards that could cause injury. Categorize the potential hazard and create a control measure that would help address any risk. These control measures would include getting regular calls from someone at regular intervals, having surveillance monitoring of the area or periodic checks by someone nearby.
Summary of tower work incidents in 2008
3/12/08 Wake Forest, NC - A 34-year-old tower tech fell approximately 130' while transitioning on a monopole.
4/14/08 San Antonio - A 38-year-old tower tech fell 225' after leaning back while loosening bolts on a guyed tower.
4/14/08 Moorcroft, WY - A tower tech fell from an unknown height.
4/17/08 Frisco, NC - A 46-year-old tower tech fell from a 90' tower onto a fence and then the ground.
4/23/08 Natchez, MS - A tower tech fell approximately 100'.
5/16/08 Haubstadt, IN - Reportedly under contract to General Dynamics, a 25-year-old fell approximately 140' while rappelling down a 200' load line at a monopole site.
5/22/08 Miami - Age unknown worker performing maintenance on the Channel 7 WSVN tower fell at approximately 12 p.m. from an unknown height.
7/18/08 Vineland, NJ - A 55-year-old tower tech fell about 60' at approximately 10:50 am from a Crown Castle tower.
7/20/08 Petersburg, ND - A 38-year-old broadcast engineer fell an estimated 100' while painting a tower.
9/12/08 Port Angeles, WA - A 33-year-old tower tech fell 32' along exterior of elevator shaft; incident occurred around midnight.
10/24/08 Ellensburg, WA - A 24-year-old Internet cable tech fell through a skylight 35' at a Ford dealership.
11/18/08 Pima Co., AZ - A 22-year-old tower tech fell from approximately 65' from a self-supporting tower.
McNamara is president of Applied Wireless, Cape Coral, FL.
Acceptable Use Policy blog comments powered by Disqus
[an error occurred while processing this directive]
Today in Radio History
The history of radio broadcasting extends beyond the work of a few famous inventors.
EAS Information More on EAS
The feed provides feeds for all US states and territories.
Need a calendar for your computer desktop? Use one of ours.
Information from manufacturers and associations about industry news, products, technology and business announcements.
A cutting-edge radio and TV broadcast media center brings hope and entertainment to a sixth pediatric hospital.
Browse Back Issues[an error occurred while processing this directive]
Also in the December Issue
- IP Audio Begins Interoperability Journey
- New Tower Construction Update Mainly for the Birds
- The FCC has been busy since the government shutdown in October 2013.
- Applied Technology: HD Voice
- Field Report: iZotope RX3 Advanced
- Side by Side: Portable Recorders
- New Life for Legacy Equipment
- Do You Remember? Gifts of Holidays Past