Most Popular Articles
Using the ULS Database
The ULS is one of those websites that has way more information than you'll ever need; here's how to make sense of it all.
Say for example you want to install a newly licensed 950MHz band system at a mountain-top transmitter site. As part of the licensing process, frequency coordination was done, and (luckily for you) your new system requirements worked out with all parties concerned (co-channel and first- and second-adjacent channel users as well). But at a mountain top site it is often very important to know what else may be going on in the RF neighborhood because, even though some users may be many megahertz away from your channel, they could still affect what you are doing.
Using this same example, let's determine if paging transmitters are located on-site, and if so, what frequencies they use. (Paging transmitters can be the bane of existence for digital STL systems.) Here's how we go about this.
Now finally, click on "search" and relax for a few minutes – it takes a little time to get the results. My search parameters were narrow and as it turns out, there isn't that much at this site, as the results show in Figure 2.
So there are at least two possible paging transmitters at the site in question. (The others were all listed as expired.) Click on the call signs and you can read their particulars. Both KNKL960 and KNKM580 are listed as active, and are licensed at the site on frequencies of 931.0625 and 931.1375 respectively. In both cases, the ERP is just over 300W.
Now that you have this information, what do you do with it? Well as I mentioned earlier, if you were installing a digital STL receiver at this site, it would be wise to install a filter ahead of it to prevent desense, which is quite likely when these 300W ERP paging transmitters key on and off. When the receiver is installed, take a spectrum analyzer along and look at the receive antenna for these particular paging transmitters. Make notes about whatever else you see between 920 and 960MHz.
There is one more thing you can do with this information. If, when you installed the transmit side of this new link, you had the antenna direction tweaked and found it to be right on your licensed parameter (as it should be), then take that spectrum analyzer, connect it to your transmit antenna, and look for these paging transmitters. Make a note of their strength. This information can be very valuable if, for some reason, you have to repair and later re-install the transmit antenna because you can use these paging transmitters as beacons for finding the site in question and at least roughing-in the bearing of the antenna in question. Also, you can conclusively determine the overall health of your transmit antenna/coax system by comparing the beacon strengths from the day of installation to those taken immediately after the repair.
Irwin is transmission systems supervisor for Clear Channel NYC and chief engineer of WKTU, New York. Contact him at email@example.com.
Acceptable Use Policy blog comments powered by Disqus
[an error occurred while processing this directive]
Today in Radio History
The history of radio broadcasting extends beyond the work of a few famous inventors.
EAS Information More on EAS
The feed provides feeds for all US states and territories.
Need a calendar for your computer desktop? Use one of ours.
Information from manufacturers and associations about industry news, products, technology and business announcements.
When Northern Community Radio set out to build a new community radio station in rural northern Minnesota 38 years ago, naysayers said that it would be broadcasting “only to a bunch of gophers
Browse Back Issues[an error occurred while processing this directive]
Also in the July Issue
- Trends in Technology: Robust IP STL
- LPFM on The March
- RF Engineering: Modern Modulation Techniques
- Field Report: Tascam TH-2000 Headphones
- Battery Maintenance: Testing and Charging